Leander Classic Junior Bed Rail: Safety and Installation Guide

Quick answer

Install the Leander Classic Junior bed rail (Sengehest) to prevent your toddler from rolling out of bed while keeping the clean, integrated look of the Leander Classic design.

Installation steps

1. 1. Prepare the bed: Ensure the Leander Classic bed is in junior mode with the Junior Kit installed. Remove any existing side panels or barriers. Check that the bed frame is stable and level before starting.
2. 2. Align the bed rail: Hold the Sengehest against the side of the junior bed at the desired height. It should sit flush against the mattress edge without gaps. Common mistake: positioning the rail too high or low, which can create a gap. The rail should be at mattress level.
3. 3. Secure the rail: Use the provided screws or brackets (not supplied with the rail, check your bed hardware) to fasten the rail to the bed frame. Tighten firmly but avoid over-tightening. If screws are missing, contact Sebra directly for replacements. Do not use non-standard hardware.
4. 4. Test for stability: Gently push and pull the rail to ensure it is securely attached. It should not move or wobble. Check that no sharp edges or exposed screws are present. Repeat this test after a few days to catch any loosening from your child's movement.
5. 5. Final safety check: Ensure the rail is at least 5 cm (2 inches) higher than the mattress top. Verify that the mattress fits snugly against the rail with no gaps larger than 2 fingers. If you use a thicker mattress later, re-check the rail height and adjust if needed.

Product facts

• Sengehest, Leander Classic™ Junior - Sleep - Hvid: The Sengehest is designed for the Leander Classic Junior bed and extends the crib for extra safety when your child sleeps. It prevents falls while making the transition from small bed to big bed easier, and it attaches without altering the bed's clean design.