Sebra Bed Baby & Jr Assembly with Plastic Rails
By sebra Officielle Webshop | Published: 2026-10-21
Category: How-to Guides
Learn how to install the plastic rails and screws for the Sebra Bed Baby & Jr. Follow step-by-step instructions for a secure fit.
Quick answer
To attach side rails to your Sebra Bed Baby & Jr, you need the plastic rails and screws set (part R and N). Align the rails with the pre-drilled holes, insert screws, and tighten evenly.
Why the plastic rails matter
The plastic rails and screws set is designed specifically for the Sebra Bed Baby & Jr frame. Without it, the side rails cannot be mounted securely. The set includes four rails (part R) and eight screws (part N), all marked with EU Ecolabel and FSC™ certifications.
Using the correct parts ensures the rails stay firmly attached during use. The set is available in gray and white to match any bed color.
What you need before starting
Check that you have the complete set: four plastic rails and eight screws. You also need a screwdriver (Phillips head) and the bed frame with the side rails removed. The bed should be on a flat, stable surface.
If you have lost the original screws or rails, the spare parts set is a direct replacement. It fits all Sebra Bed Baby & Jr models.
Step-by-step assembly
- 1. Position the first rail: Take one plastic rail (part R) and align it with the pre-drilled holes on the inside of the bed frame. The rail should sit flush against the wood. Do not force the rail if it does not align; check that you are using the correct side (left vs right).
- 2. Insert the screws: Insert two screws (part N) through the rail holes into the frame. Tighten them by hand first, then use a screwdriver to secure them fully. Repeat for the remaining three rails. Over-tightening can strip the plastic or wood; stop when the screw head is snug against the rail.
- 3. Attach the side rails: Slide the side rail brackets onto the installed plastic rails. Push down until you hear a click or feel them lock into place. Test by gently pulling upward. If the side rail does not click, the rail may be upside down or the screws are too tight. Loosen slightly and try again.
- 4. Check all connections: Once all four rails and both side rails are mounted, shake the bed gently. No movement should occur. Tighten any loose screws. A loose side rail can be a safety hazard. Recheck after the first week of use as wood can settle.
Product facts
- Plastikskinner og skruer til montering af tremmesider på Sebra Sengen, Baby & Jr. - Sebra Spareparts - Grå: The set includes 4 plastic rails (part R) and 8 screws (part N) for attaching side rails to the Sebra Bed Baby & Jr. You need exactly these parts to mount the side rails securely; using generic hardware may not fit or could compromise safety.
Plastikskinner og skruer til montering af tremmesider på Sebra Sengen, Baby & Jr. - Sebra Spareparts - Grå
