Vægmonteret sengehimmelholder til Sebra Sleep: Guide

By sebra Officielle Webshop | Published: 2026-10-22

Category: How-to Guides

Learn how to mount the Sebra Sleep wall-mounted canopy holder in a baby room. Step-by-step instructions for a safe, elegant installation.

Quick answer

Mount the Sebra Sleep wall-mounted canopy holder with the two included white-lacquered screws. Follow the steps below to ensure a secure, level fit on your wall.

Why choose a wall-mounted holder?

A wall-mounted canopy holder is ideal when the ceiling is too high, sloped, or unsuitable for drilling. It also lets you position the canopy exactly where you want it above the crib, creating a cozy sleeping nook without altering the ceiling.

What you need before starting

You only need the holder itself (with two screws included), a drill with a suitable bit for your wall type, a level, and a pencil for marking. No additional hardware is required for standard drywall or wood studs.

Monteringstrin

Choose the mounting spot: Hold the canopy holder against the wall above the crib at the desired height. Use a level to ensure it is straight, then mark the two screw holes with a pencil. Double-check that the holder is centered over the crib and that the canopy won't touch the baby's face.
Drill pilot holes: Select a drill bit slightly smaller than the screws. Drill pilot holes at the marked points. For drywall, use wall anchors if needed (not included). For wood studs, drill directly into the stud. Common mistake: drilling without a level can cause the holder to tilt. Always check alignment before drilling.
Attach the holder: Align the holder's holes with the pilot holes. Insert the two white-lacquered screws and tighten them firmly with a screwdriver. Do not overtighten, as this may damage the wood. After tightening, give the holder a gentle tug to confirm it is secure before hanging the canopy.
Hang the canopy: Drape the canopy over the holder's arms. Adjust the fabric so it falls evenly around the crib. Ensure the canopy does not obstruct ventilation or create a suffocation hazard. Never leave loose fabric within reach of the baby. Tuck or trim any excess material.

Product facts

Vægmonteret sengehimmel-holder - Sebra Sleep - Classic white: Elegant wall-mounted wooden holder with two included white-lacquered screws that match the holder for a finished look. The matching screws eliminate the need to paint or hide fasteners, so the installation looks seamless from the start.
Vægmonteret sengehimmel-holder - Sebra Sleep - Classic white